www.fmiproducts.com
124387-01D
20
CONNECTING FIREPLACE TO GAS
SUPPLY
WARNING: Gas line hookup
should be done by your gas
supplier or a qualified service
person.
CAUTION: Do not kink flex
-
ible gas line.
CAUTION: Compounds used
on threaded joints of gas piping
shall be resistant to the action
of Liquefied Petroleum (LP or
propane) and should be applied
lightly to ensure excess sealant
does not enter the gas line.
INSTALLATION
Continued
Rating
Plate
Hole for Screen
Rod
Leading Bricks
Figure 30 - Installing Fireplace Screen
INSTALLING SCREEN
1. Slide round end of screen rod into rings at
top of screen. Attach one push-on nut to end
of rod before attaching last ring of screen.
2. Insert the round end screen rod into hole
on the left and right side of smoke shelf
(Figure 30).
3. Mount flat end of screen rod with #10 x 5/8"
to center of smoke shelf.
4. Install other screen rod in same manner.
WARNING: All gas piping
and connections must be tested
for leaks after the installation is
completed.
After ensuring that gas valve
is on, apply a commercial leak
detection solution to all con-
nections and joints. If bubbles
appear, leaks can be detected
and corrected.
Do not use an open flame for leak
testing and do not operate any
appliance if a leak is detected.
Complete your gas installation by connect-
ing incoming gas line with flexible gas line
attached to the log/burner module. Secure
tightly with wrench but
DO NOT OVER-
TIGHTEN
.
Apply pipe joint sealant lightly to male NPT
threads. This will prevent excess sealant from
going into pipe. Excess sealant in pipe could
result in clogged fireplace valves.
Installation Items Needed
• 5/16" hex socket wrench or nut-driver
• sealant (resistant to propane/LP gas, not
provided)
1. Route flexible gas line supplied with log/
burner module through the large hole on
the firebox bottom to the incoming gas line
(Figure 25, page 18).
2. Attach flexible gas line from gas supply to
control valve (see Figure 31, page 21).
3. Check all gas connections for leaks. See
Checking Gas Connections,
page 22.