FMC M12-HD, Operation & Maintenance Manual, Page: 2 / 20

F M C M 1 2 - H D O P E R A T I O N A N D M A I N T E N A N C E M A N U A L
2
FMC Safety Instructions
Many accidents occur through the careless operation and maintenance of mechanical
equipment. You can avoid hazards associated with the use of high-pressure
mechanical equipment provided by FMC by always following the safety precautions
listed below. If these warnings are not followed, bodily injury including death could
occur to you or other persons. FMC cannot anticipate every possible circumstance
that might involve a potential hazard, therefore the warnings listed in this publication
are not inclusive. As the user, you must decide if a particular operating mode, repair
technique, or tool is safe before performing or using.
The procedures and illustrations provided in this manual are based on the best
information available at the time of publication. Procedures, specifications, torque
requirements, and other values may be updated at any time. Always contact FMC or
your FMC equipment dealer for the most complete and current information before
starting any repair job. Contact FMC any time if you are unsure about any procedure
involving FMC equipment.
•
Do not perform any operation, maintenance, or lubrication of this equipment until
you have read and understood the information provided to you in this manual and
any additional information provided by the manufacture of the equipment the pump
was supplied with.
•
Never attempt a service procedure until you are certain all pressure has been
removed from the pump and the drive is disengaged and locked out.
•
Never operate the pump without a relief valve, rupture disk, or other type of
overpressure safety device properly installed.
•
Never exceed the rated pressure or speed of the pump for any reason.
•
Never operate the pump without proper guards in place for all moving parts.
•
Use caution when solvents are used to clean or degrease equipment. Most
solvents are highly flammable.