FMA Direct T-80RF, User Manual

Page: 8 / 12

T-80RF user’s guide – 8 – FMA Direct
D. Set control throw directions (servo reversing).
You must assure that the aircraft’s control surfaces and throttle
move in the correct directions. If they move in the incorrect di-
rections, you will not be able to control your airplane.
1. Turn on the transmitter, then turn on the receiver.
2. Move each control stick on the transmitter, and compare the
airplane’s control surfaces and throttle with the pictures on
this page and the next page (depending on your airplane’s
configuration).
3. If a surface or the throttle moves in the wrong direction, use
a small flat-blade screwdriver to change the position of the
corresponding channel switch in the
Reverse section of the
transmitter’s front panel. Check control movement again.
Setting up the radio system — continued
Conventional controls
Rear view
Rear view
Roll control (aileron, channel 2*)
Roll right
Roll left
Rear view
Rear view
Pitch control (elevator, channel 1*)
Pitch up
Pitch down
Rear view
Rear view
Yaw control (rudder, channel 4*)
Yaw right
Yaw left
CAUTION: If you are at or near a flying field, ob-
serve frequency control rules and comply with local
procedures before turning on your transmitter. When
the transmitter is on—
even for a few seconds , it is
radiating radio frequencies which may interfere with
a radio system already operating on the same fre-
quency.