SHIPPING INSPECTION
Remove from shipping container and inspect for shipping
damage. The ACE472 is a Slide-in Card that fits into the RMS-400
Mainframe and Power Supply. The card is supplied with a retaining screw
(attached to the PC Board), a Front Label Designator and this
instruction book. If an RMS-400 Mainframe and Power Supply was purchased
with a ACE472 Card, the Card will be installed at the factory into the
Mainframe with labels attached and the retaining screw engaged and
locked.
HOW AND WHERE TO MOUNT THE UNIT
Select a position for the RMS-400 that is near the video
recorder, monitor or other equipment that needs video control. The
placement is not critical. Then install the ACE472 PC CARD in any unused
CARD SLOT that is empty. Follow the instructions for card installation,
be sure to remove the retaining screw on the front of the card and not
to apply excessive force to the card during installation.
MODULE CARD INSTALLATION
1.
Select one of the un-used nine positions to be occupied by the new
circuit board module.
2.
Remove the blank label in that position by peeling it off of the
front panel. Peel the label slowly to remove all of the label and
adhesive. Any remaining adhesive may be removed by rubbing the
surface with your thumb. WARNING: DO NOT USE SOLVENTS TO REMOVE THE
LABEL ADHESIVE. The solvent could damage the equipment cards or
cause a fire.
3.
Peel the backing off of the new label and apply it to the front
panel of the RMS-400 rack in the position of the new card. Align
the new label with the screw head in the hole in the lower right
hand corner of the label, then align the center thumbscrew with the
clearance hole in the front panel. This should cause the label to
be straight and vertical. When the label is in place press firmly
the secure the label.
4.
Then remove the thumb-screw retainer from the product card, it is
located at the front of the card and is removed by rotating the
knob counter-clock-wise.
5.
Select any and all product options on the specific card.
6.
Next slide the card into the card guides at the rear of the RMS-
400. Be sure that the notch in the circuit card is facing forward
and down. Push the card all the way to the front of the rack until
it stops. DO NOT APPLY EXCESSIVE FORCE TO THE CARD.
7.
Insert the thumb-screw that was removed in step 4 while
rotating it in a clock-wise direction. When it begins to thread
into the card, continue until it is finger tight. CAUTION TIGHTEN
BY HAND ONLY, DO NOT USE TOOLS TO TIGHTEN THE THUMB-SCREW. OVER
TIGHTENING WILL DAMAGE THE CIRCUIT CARD.
8.
Attach any cables or wires necessary for operation.
ACE472.ISB
Page
2
of
4