background image

2

PROTECT YOUR  MODEL, YOURSELF

AND OTHERS; FOLLOW THESE 

IMPORTANT SAFETY PRECAUTIONS

Your SkyFly 2 should not be considered a toy, but 
rather a sophisticated, working model that functions 
very much like a full-size airplane. Because of its 
performance capabilities, the SkyFly 2, if not assembled 
and operated correctly, could possibly cause injury to 
you or spectators and damage to property.

We highly recommend that you get experienced, 
knowledgeable help with assembly and during 
your fi rst  fl ights. This will make your modeling 
experience more enjoyable.

 You’ll learn faster and 

avoid risking your model before you are truly ready 
to solo. Your local hobby shop has information about 
fl ying clubs in your area whose membership includes 
qualifi ed instructors. You can contact the 

Academy 

of Model Aeronautics (AMA)

, which has more than 

2,500 chartered clubs across the country. Instructor 
training programs and insured newcomer training are 
available through any one of these clubs.

Contact the AMA at the address or toll-free phone 
number below.

Academy of Model Aeronautics

5151 East Memorial Drive

Muncie, IN 47302

(800) 435-9262 Fax: (765) 741-0057

or via the Internet at: 

www.modelaircraft.org

PRECAUTIONS

1. Assemble the plane 

according to instructions

DO NOT 

alter or modify the model. If you make any 

modifi cations, you void your warranty.

2. 

Test

 the operation of the model 

before each fl ight

to insure that all equipment is operating properly and 
that the model remains structurally sound.

3. Fly only on calm days (with wind speeds less than 
5mph) and in large, open areas free of trees, people, 
buildings, or any other obstacles.

Remember: Take your time and follow the 

instructions to end up with a well-built model 
that is durable and easy to fl y. 

The R/C model 

hobby becomes more and more enjoyable as your 
experience grows. Your chances for success and 
graduation to higher levels are very good if you 
take your time and follow the assembly and fl ying 
instructions carefully and completely. We hope you 
enjoy fl ying your SkyFly 2 airplane.

GLOSSARY

Electronic Speed Control/Receiver (ESC/RX):

 

This unit controls the speed of the motor and 
control surfaces.

Elevator:

 Control altitude.

Rudder:

 Controls direction.

Nickel-Metal Hydride (NiMH) Battery:

Rechargeable batteries which are used to power the 
airplane. NiMH batteries are lighter and smaller than 
most other types of rechargeable batteries.

Transmitter (TX):

 This is the hand-held unit that 

sends the signal to the control unit (or RX). Moving the 
controls will control speed, altitude and direction.

3-CHANNEL RADIO

CONTROL SYSTEM

 

NOR

 

REV

CH3

 

CH2

 

CH1

 

TTX300

 

ON

 

TACTIC

 

 

CONROL STICK

ELEVATOR TRIM

THROTTLE

SLIDE

POWER

LED

RUDDER TRIM

ON/OFF SWITCH

Battery

Motor

ESC/
Receiver

ANTENNA

Summary of Contents for Sky Fly 2













Reviews: