™
rcaircore.com
FLZA3907
OPTIONAL INSTALLATION of ANTENNA
OPTIONAL INSTALLATION of WING CANNONS
RANGE CHECK
With the transmitter powered and the battery plugged into
the AirCore Module, walk 50’ [15m] from the aircraft and
check the control functions for proper and smooth operation.
FLYING THE AIRCORE AIRPLANES
Take off (or hand launch) directly into the wind.
Hand launch with throttle set at ¾ power, wings level and
with a slight toss (it is not necessary to aggressively throw
this model to hand launch it).
Once in the air, gain altitude to allow yourself suffi cient
reaction time to make a correction during fl ight.
Once you’re comfortable, adjust the aileron, elevator
and rudder trims one click at a time until the Spitfi re
fl ies straight and level with the control sticks centered.
You will quickly notice that the Spitfi re has the feel of a larger
R/C airplane. The airplane requires only small amounts of
control stick movement to fl y smoothly.
It’s recommended that you attempt to land before the motor
loses power and doesn’t have enough voltage to maintain
altitude. If you have a timer on your transmitter, set it for
4-minutes for the fi rst couple of fl ights. Then, gradually
increase the fl ight time to fi t your fl ying style. Allow at least an
extra 1-minute of fl ight time for a second attempt at landing.
If possible, always land directly into the wind.
Gradually reduce power when you are close to the landing
spot. When close to the ground and about to touch down,
pull the elevator stick back slightly to raise the nose of the
model and to “fl are” for landing.
Unplug and remove the battery from the model and
switch off the transmitter. Allow the motor to cool
between flights.
REPAIRS
Repairs can be made to the AirCore Spitfi re by using the
following items:
●
Formula ‘560’ Canopy Glue (highly recommended)
(PAAR3300)
●
Thick Foam Safe CA (for quick fi eld repairs)
(GPMR6072)
●
Foam safe CA accelerator (GPMR6035)
●
Two pairs of needle nose pliers or hemostats
(HCAR0625)
●
Hobby Knife (#11 blade) (RMXR6900)
●
Electric Flyer Hinge Tape (DUBQ0916)
REPLACEMENT PARTS
To order replacement parts for the AirCore Spitfi re, use the
stock numbers in the list below. Replacement parts are
available as listed. Replacement parts are not available
from Product Support, but can be purchased from hobby
shops or mail order/Internet order fi rms. If you need
assistance locating a dealer to purchase parts, contact:
Product Support
Phone: 217-398-0007
Fax:
217-398-7721
E-mail: [email protected]
or go to www.rcaircore.com and click on "Where to Buy."
Stock No. Description
●
FLZA6406 AirCore Spitfi re Spinner
●
FLZA6436 AirCore Spitfi re Fuselage
●
FLZA6440 AirCore
Spitfi
re
Wing
●
FLZA6444 AirCore Spitfi re Hatch
●
FLZA6448 AirCore Spitfi re Landing Gear
●
FLZA6427 AirCore Airframe Push Rod Set
●
FLZA6428 AirCore Hardware Set
