FLYSURFER Speed4 Lotus, Gear Manual, Page: 63 / 68

Bring the C-Leg up to the A
and Z legs and tension the mixer.
All three knots should be at the
same level at standard trim.
If this is not the case, you just have to
move the metal ring of the mixer (C-Leg)
until all 3 knots are at the same level.
Tip : The mixer is basically
a 2-1 pulley system. If you
want to change the B-Leg
by one centimeter, you will
need to move the ring by
two centimeters.
Bring the B-Leg up to the A, C and
Z legs and tension the mixer. All four
knots should be at the same level
at standard trim.
EN
63
13
T
R
IMMI
N
G
If this is not the case, you just have to
move the metal ring of the mixer (B-Leg)
until all four knots are at the same level.
Done. Be sure to pull everything
properly tight again after adjusting,
so that the trim stays under tension.
Tip: When the mixer is set
to the standard trim (0),
e.g. all four knots are at the
same level. It is enough to
only move the metal ring of
the mixer (C-Leg) to change
the basic trim. The B-Leg
automatically adjusts half
the amount of the C-Leg
when modifying.
13.02 Optimum trim
of the flying lines
Steering (back) lines shorten over time
in relation to the flying (front) lines.
Underneath the floaters, the back line
can be shortened or extended by using
knots. Extension of the back lines is
necessary when the trimmer needs to
be pulled in too much to keep the kite fly-
ing normally in its intended wind range.