EN
GL
ISH
13
SA
fE
Ty
S
yS
TE
M
Auslösen des Standard Safety Modus
When you reach the bar, secure the endline to your harness
hook. This is done by wrapping the side of the endline which is
under tension two times around the harness hook and then the
loose side one time in the opposite direction.
When the endline is secured, the quick release can be reas-
sembled. Place the end of the chicken loop over the trigger pin
while holding the red activation handle open.
Let the chicken loop go and unwrap the endline. Make sure
you have a good grip on the endline as you hook in the chicken
loop and secure it with the chicken dick.
Slowly release the endline bit by bit. Make sure that it has
not wrapped itself around any part of your body. Do not let the
endline slip too quickly through your fingers as to avoid getting
burns or cuts. Because of this, it is recommended that you let go
of the entire endline when you get to the last two meters.
07 SAfETy SySTEM
The PEAK4 kites are equipped with our B-Safe system. Af-
ter activating the quick release, the control bar slides up to the
stopper knot.
The kite falls from the sky without pressure.
07.01 Reactivating the kite
After leashing out, the kite can easily be reset on the ground and
relaunched again.
Work your way up the Safety-Endline until you get to the
control bar. Be careful not to get tangled in the loose endline.
Zusammenbau des QR
Zusammenbau des QR
Zusammenbau des QR
Zusammenbau des QR