Flyron Technology Limited
PIR Motion Sensor Activated Audio Player(FNP-702A)
E-mail: [email protected]
5
This product uses a rechargeable 3.7V lithium battery, and it also can be connected a power
adaptor/charger(DC5V/1A) for power supply. When you connect the device to the power adaptor, the external
power charges the lithium battery and supply power to the host device in the same time. It supports battery
charging at working state and power off state.
Under working state for battery charging, the LED indicator keeps glowing and the host device will not enter into
sleep mode. It can work normally once the sensor is triggered.
Under power off state for battery charging, there is no indication. The lithium battery will be full of power after 4
hours charging.
4.3 Power-on Operation
When the device is switched on(the LED indicator is turned on), it gets into initialization for about 15 secs. During
this, it is normal that there is no any reaction from it. After that it starts to work normally that when the sensor is
triggered, it plays a pre-loaded sound automatically. The interval time is 1-3 secs between each triggering.
4.4 Load / Update Audio Files
Before you load/update new audio file to the device, firstly please prepare a PC and an empty TF card(micro SD
card) with FAT32 file system, and then put the MP3 files to the TF card though PC(any file name is available, but
can not put other files in the TF card). After MP3 files copied completely on PC, insert the TF card to the TF socket
of this product(insert the TF card according to the TF card socket label). At this moment, if you switch on the
player, after being triggered it will play the MP3 files stored in the TF card directly once the inserted TF card is
detected.
If the total time duration of all your audio files(based on 128Kbps of MP3 files) is no more than 4 minutes, you can
copy the audio files to the internal flash to save the cost of a TF card. Please follow the steps below to copy MP3
files from the TF card to the internal flash.
1). Firstly, make sure the player is switched off.
2). Insert the TF card already stored the MP3 files to the player correctly.
3). Use a finger to press Key A and hold, then switch on the player with the other hand. Don’t leave your finger on
Key A until the LED indicator starts to blink.
4). Now release Key A when the indicator starts to blink, which means the device is copying the audio files from
