background image

4. Immediately disconnect from the mains electricity sup-

ply if the cable is cut, or the insulation is damaged.  Do
not touch the electric cable until the electrical supply
has been disconnected.  Do not repair a cut or dam-
aged cable.  Replace it with a new one.

5. Your extension cable must be uncoiled, coiled cables

can overheat and reduce the efficiency of your mower.

6.  Keep cable away from lawnmower, always work

away from the power point mowing up and down,
never in circles.

7. Do not pull cable around sharp objects.
8. Always switch off at the mains before disconnecting

any plug,  cable connector or extension cable.

9. Switch off, remove plug from mains and examine electric

supply cable for damage or ageing 

b e fo r e

winding cable

for storage.  Do not repair a damaged cable, replace it
with a new one.  Use only Flymo replacement cable.

10.Always wind cable carefully, avoiding kinking.
11. Never carry the product by the cable.
12.Never pull on the cable to disconnect any of the plugs.
13.Use only on AC mains supply voltage shown on the

product rating label.

14.Our products are double insulated to EN60335.

Under no circumstance should an earth be con-
nected to any part of the product.

Preparation

1. While using your product, always wear substantial

footwear and long trousers.

2. Make sure the lawn is clear of sticks, stones, bones,

wire and debris; they could be thrown by the blade.

3. Before using the machine and after any impact, check

for signs of wear or damage and repair as necessary.

4. Replace worn or damaged blades together with

their fixings in sets to preserve balance.

Use

1. Use the lawnmower only in daylight or good artificial light.
2. Avoid operating your lawnmower in wet grass,

where feasible.

3. Take care in wet grass, you may lose your footing. 
4. On slopes, be extra careful of your footing and

wear non-slip footwear.

5. Mow across the face of slopes, never up and down.
6. Exercise extreme caution when changing direction

on slopes. Walk never run.

7. Mowing on banks and slopes can be dangerous.

Do not mow on 

banks

or 

steep

slopes. 

8. Do not walk backwards when mowing, you could trip.
9. Never cut grass by pulling the mower towards you.
10.Switch off before pushing the mower over surfaces

other than grass.

11. Never operate the lawnmower with damaged

guards or without guards in place.

12.Keep hands and feet away from the cutting means at

all times and especially when switching on the motor.

13.Do not tilt lawnmower when the motor is running,

except when starting and stopping.  In this case, do
not  tilt more than absolutely necessary and lift only the
part which is away from the operator.  Always ensure
that both hands are in the operating position before
returning the appliance to the ground.

14.Never pick up or carry a mower when it is operating

or still connected to the mains supply.

15.Remove the plug from the mains :
-

before leaving the mower unattended for any period;

-

before clearing a blockage;

-

before checking, cleaning or working on the appliance;

-

if you hit an object.  Do not use your lawnmower
until you are sure that the entire lawnmower is in a
safe operating condition;

-

if the lawnmower starts to vibrate abnormally.  Check
i m m e d i a t e l y.  Excessive vibration can cause injury.

Maintenance and storage

1. Keep all nuts, bolts and screws tight to be sure the

lawnmower is in safe working condition.

2. Check the grassbox/grassbag frequently for wear or

deterioration. 

3. Replace worn or damaged parts for safety.
4. Only use the replacement blade, blade bolt, spacer

and impeller specified for this product.

5. Be careful during adjustment of the lawnmower to

prevent entrapment of the fingers between moving
blades and fixed parts of the machine.

CABLES
IMPORTANT

Use only 1.00mm

2

size cable up to 40 metres length

maximum.

M a x i mum rating :

1 . 0 0 m m

2  

size cable, 10 amps 250 volts A C .

THE TURBO COMPACT IS SUPPLIED WITH AN
ELECTRIC MAINS CABLE FITTED WITH A
FEMALE CONNECTOR

1. Flymo Mains Cables and Extension Cables are

available from your local Electrolux Outdoor
Products Approved Service Centre.  

2. Do not wire an extension cable directly to your product

yourself.  Please contact your local Electrolux Outdoor
Products Approved Service Centre for further informa-
tion on the connectors and kits available.

3. Only use extension cables specifically designed for

outdoor use.

CONNECTORS
IMPORTANT

Flymo connectors are suitable for use with 2 core
cable only.  Under no circumstances should these
connectors be used for earthed products.

All Flymo connectors and cables are of splashproof con-
struction.  They are not waterproof and must not be left
outside permanently nor should they be submerged or
immersed in water.  Do not let cable lay or trail through
pools of water or splashed with water from hose pipes.

MAINS PLUG REPLACEMENT
IMPORTANT

If the plug supplied is cut off it should be
destroyed. There is an electric shock hazard if a
cut off plug is inserted into a 13 amp socket.

1.

No earth required.

Flymo products are double insulated

to EN60335  and under no circumstances should an
earth be connected to any part of the product.

2.

Ensure the mains voltage suits your product

3.

IMPORTANT!  

The wires in the mains lead are coloured in accor-
dance with the following code:
BLUE         -      NEUTRAL
BROWN     -      LIVE
The wire which is coloured BLUE must be connect-
ed to the Terminal which is marked with the letter 'N'
or coloured BLACK.  
The wire which is coloured BROWN must be con-
nected to the Terminal which is marked with the let-
ter 'L' or coloured RED. 

4. It is important that the outer sheath is clamped cor-

rectly into the 3-pin plug. 

5. If in doubt consult your local Service Repairer or

qualified electrician before the machine is used.  

6.

A 13 Amp fuse must be fitted to the Mains Plug.

7. The normal plug fuse and household fuse only pro-

tect the electrical equipment and are not a safe-
guard against electrocution.

Cables

If your product is hard wired i.e. non-detachable
mains electric cable, a conversion kit and exten-
sion cable is available from all Electrolux Outdoor
Products Approved Service Centres which can be
found in your local Yellow Pages.

Summary of Contents for TURBO COMPACT 330









Reviews: