4
6. Do not wear clothing with attach-
ments, i.e. toggles or drawstrings
that can be drawn into the air inlet.
7. Inspect your product before each
use. Replace any worn or dam-
aged parts.
8. Do not use if any part is damaged
or broken or if any of the screws
are loose. Have it repaired by an
authorised repairer.
9. Always check your product is in a
safe operating condition before use.
Use
1. Use the product only in daylight or
good artificial light.
2. Do not use the product when it is
raining or in damp and wet areas.
3. Never use the product in or near
water or ponds.
4. Know how to stop the product
quickly in an emergency.
5. On slopes, be extra careful of your
footing and wear non--slip footwear.
6. Never pick up or carry the product
by the cable.
7. Keep children, pets and bystand-
ers at a safe distance when using
your product.
8. Keep long hair away from air inlet.
9. Keep all inlets clear of debris.
10. Always remain alert.
11. Do not attempt to use your product
for vacuuming without the fully as-
sembled debris bag fitted.
12. Never blow debris in the direction
of bystanders.
13. Do not overreach. Keep proper
footing and balance at all times.
14. Remove the plug from the mains :
-- before removing or replacing
fully assembled debris bag;
-- before leaving the product unat-
tended for any period;
-- before clearing a blockage;
-- before checking or cleaning the
appliance;
-- if the product starts to vibrate
abnormally. Check immediately.
Excessive vibration can cause
injury.
Maintenance and storage
1. Keep all nuts, bolts and screws
tight to be sure the product is in a
safe working condition.
2. Replace worn or damaged parts for
safety.
3. After use the product should be
stored in a safe place where it is
protected from damage.
4. Inspect the collection bag regularly.
If the collection bag becomes worn
or damaged, replace.
Cables
IMPORTANT
Use only 1.00mm
2
size cable up to 30
metres length maximum.
Maximum rating :
1.00mm
2
size cable, 10 amps 250
volts AC.
1. Mains cables and extensions are
available from your local Electrolux
Outdoor Products Approved Ser-
vice Centre.
2. Only use extension cables specifi-
cally designed for outdoor use.
Assembly Instructions
WARNING:
Stop the unit and dis-
connect the mains electricity supply be-
fore opening the inlet cover or attempting
to insert or remove the inlet restrictor,
blower tube, or vacuum tubes. The motor
must be stopped and the impeller blades
no longer turning to avoid serious injury
from the rotating blades.
WARNING:
If received assembled,
ensure your unit is properly assembled
and all fasteners are secure.
S
A standard screwdriver is required
for assembly.
Blower Assembly
NOTE:
Assembly instructions for using
your unit as a vacuum follow this sec-
tion.
Attaching the blower tube
If you have already assembled your
unit for use as a vacuum, refer to the
section
HOW TO CONVERT UNIT FROM
VACUUM USE TO BLOWER USE.
To attach blower tube:
1. Align the grooves on the blower tube
with the grooves on the blower outlet.
2. Push the blower tube onto the blower
outlet until it snaps into place (tube is
secured by orange tube release but-
ton).
