Fault Finding Chart
WARNING Disconnect from the mains electricity supply before attempting any maintenance or adjustment.
FAULT
CHECK
ACTION
Is the automatic line feed
working?
Manually feed out line.
SEE “MANUAL LINE FEED”
Is the line fed out and visible?
Has line been removed from
cleat?
Remove cap and spool, free line
and re-fit spool and cap. SEE
“CUTTING HEAD”
The line may be jammed on the
spool. Rewind line to remove
crossed loops. Check that line is in
correct section of spool.
Is the manual line feed working?
Has too much line been fed out?
SEE “MANUAL LINE FEED”
Contact your local approved
Service Centre or Husqvarna UK
Ltd. Customer Service.
Is the line cutter missing from the
safety guard?
Contact Husqvarna UK Ltd. Customer Service
Telephone : 0844 844 4558 UK
1800 882 350 ROI
No
No
No
Yes
Yes
LINE NOT FEEDING
OR
LINE TOO SHORT
OR
TRIMMER VIBRATES
CONTINUOUS
CLATTERING NOISE
LINE SNAPS
CONTINUOUSLY
IF NONE OF THE ABOVE
OR IF FAULT PERSISTS
Has the motor reached full speed
before use?
No
Allow the motor to reach full speed
before use.
Are you using the trimmer
correctly?
?
Only use tip of nylon line to trim.
SEE “How to trim and edge”
Is the line jamming on the spool?
Yes
Rewind the line on the spool, if
symptoms still persist, change
spool and line.
Maintenance
W
V
•
WARNING
Disconnect from the mains electricity supply, before
attempting any maintenance or adjustment. Cutting
head continues to rotate after the trimmer has been
switched off. Keep fingers and hands clear of the line
cutter on leading edge of guard.
Caring for your product
After you have finished using your product follow the
procedure below:
AVOID ACCIDENTAL STARTING. REMOVE PLUG
FROM MAINS AND KEEP FEET AWAY FROM THE
SWITCH LEVER WHEN: CLEANING AROUND THE
INSIDE OF THE SAFETY GUARD, REMOVING OR
REFITTING SPOOL CAP, MANUALLY FEEDING OR
REPLACING NYLON LINE.
1.
Disconnect from the mains electricity supply.
2.
Never clean your trimmer with water, cleaning fluids, or
solvents, just remove debris with a suitable tool, a soft
brush or dry cloth.
3.
Using a soft brush, clean around the inside of the
safety guard, the cutting head (V) and the motor
housing air vents. (W)
4.
Inspect the trimmer carefully, especially the parts of
the cutting head.
5.
If your trimmer is damaged in any way contact your
local approved service centre.
•
Never use a damaged trimmer.
6.
Store in a cool, dry place and out of reach of children.
Cable Storage
1.
Your mains cable can be stored on the product as
illustrated in Fig X1.
2.
Wind cable carefully to avoid kinking.
3.
To release the cable press the button and the hook will
drop down (X2).
4.
Push cable hook fully back into position.
X2
X1
Replacement Parts
Spool and Line
Reference no.:
FLY021
Part no.:
513937190
