background image

Maintenance and storage
1. Keep all nuts, bolts, and screws tight to be sure

the machine is in safe working condition.

2. Check the grass collector frequently for wear or

deterioration.

3. On machines with multi blade, take care as

rotating one blade can cause other blades rotate.

4. Be careful during adjustment of the machine to

prevent entrapment of the fingers between

moving blades and fixed parts of the machine.

5. Always allow the machine to cool down before

storing.

6. When servicing the blades be aware that, even

though the power source is switched off, the

blades can still be moved.

7. Replace worn or damaged parts for safety. Use

only genuine replacement parts and accessories.

Additional safety instructions

Electrical safety

WARNING!
• Cardiac arrest!
• This product makes an

electromagnetic field while it

operates. This field may under some

conditions interfere with active or

passive medical implants.

• To decrease the risk of conditions

that can possibly injure or kill, we

recommend persons with medical

implants to speak with their physician

and the medical implant

manufacturer before you operate the

product.

Before use, examine the cable for signs of damage

or ageing. If the cable is found to be defective, take

the product to an Authorised Service Centre and

have the cable replaced.
Do not use the product if the electric cables are

damaged or worn.
Immediately disconnect from the mains if the cable is

cut, or the insulation is damaged. Do not touch the

electric cable until the cable has been disconnected.

Do not repair a cut or damaged cable. Replace it

with a new one.
The extension cable must be uncoiled. Coiled cables

can overheat and reduce the efficiency of your

mower.
Keep the extension cable away from product, always

work away from the power point mowing up and

down, never in circles.
Do not pull cable around sharp objects.
Always switch off at the mains before disconnecting

any plug, cable connector or extension cable.

Stop the engine, disconnect the mains and examine

the cable for damage or ageing before you wind the

cable for storage. Do not repair a damaged cable,

replace it with a new one. Use only genuine

replacement cable.
Always wind the cable carefully, avoid kinking.
Do not carry the product by the cable.
Do not pull on the cable to disconnect any of the

plugs.
Use only on AC mains supply voltage shown on the

product rating label.
Our products are double insulated to EN60335. Do

not connect an earth to any part of the product.
Check the working area for hidden cables.
Do not use for pond care or close to water.

Personal safety

WARNING!
• Risk of suffocation
• Small parts can be easily swallowed.

There is also a risk that the polybag

can suffocate toddlers.

• Keep toddlers away when you

assemble the product.

Do not use in explosive atmosphere.
Do not operate the product when you are tired, ill or

under the influence of alcohol, drugs or medicine or

you exhaustid.
Do not overload the mower.
Use gloves, wear slip resistant shoes and wear eye

protection.
Do not use under wet conditions.
Do not use on wet grass.
Do not disassemble the product further than the

delivery status.
Only start the mower with an upright standed handle.
Do not use the start levers alternately.
Use the handles carefully.

Safety Cut-Out
The engine is protected by a Safety Cut-Out which is

activated when the blade becomes jammed or if the

engine is overloaded. When this occurs, stop and

disconnect the product from the mains. The Safety

Cut-Out will only reset when you release the start/

stop lever. Clear any obstruction and wait for a few

minutes for the Safety Cut-Out to reset before you

continue to use the product.

17 - 001 - 

7

Summary of Contents for Glider Compact 330 VC





















Reviews: