Flymo CONTOUR POWERPLUS CORDLESS CCT250, Instruction Manual, Page: 8 / 10

Y
X
Maintenance
W V
• WARNING
Cutting head continues to rotate after the
trimmer has been switched off. Keep fingers
and hands clear of the line cutter on leading
edge of guard.
Caring
After you have finished using your product follow the
procedure below:
AVOID ACCIDENTAL STARTING. KEEP FEET
AWAY FROM THE SWITCH LEVER WHEN:
CLEANING AROUND THE INSIDE OF THE
SAFETY GUARD, REMOVING OR REFITTING
SPOOL CAP, MANUALLY FEEDING OR REPLAC-
ING NYLON LINE.
1. Disconnect from the mains electricity supply.
2. Never clean your trimmer with water, cleaning flu-
ids, or solvents, just remove debris with a suitable
tool, a soft brush or dry cloth.
3. Using a soft brush, clean around the inside of the
safety guard, the cutting head (Fig V) and the
motor housing air vents. (Fig W)
4. Remove the wheel by pressing one of the buttons.
Clean the wheel and groove on trimmer head with
a soft brush
(X & Y) .
5. Attach wheel as described in Wheel Assembly .
6. Inspect the trimmer carefully, especially the parts
of the cutting head.
7. If your trimmer is damaged in any way contact
your local approved service centre.
• Never use a damaged trimmer.
8. Store in a cool, dry place and out of reach of chil-
dren.
Fault Finding Chart
FAULT CHECK ACTION
Is the automatic line feed work-
ing? Manually feed out line.
SEE “MANUAL LINE FEED”
Is the line fed out and visible?
Has line been removed from
cleat? Remove cap and spool, free line
and re-fit spool and cap.
SEE
“CUTTING HEAD”
The line may be jammed on the
spool. Rewind line to remove
crossed loops. Check that line is in
correct section of spool.
Is the manual line feed working?
Has too much line been fed out? SEE “MANUAL LINE FEED”
Contact your local approved Service
Centre or Husqvarna UK Ltd. Cus-
tomer Service.
Is the line cutter missing from the
safety guard?
Contact Husqvarna UK Ltd. Customer Service
Telephone : 01325 300303
No
No
No
Yes
Yes
LINE NOT FEEDING
OR
LINE TOO SHORT
OR
TRIMMER VIBRATES
CONTINUOUS CLATTER-
ING NOISE
LINE SNAPS CONTINU-
OUSLY
IF NONE OF THE ABOVE
OR IF FAULT PERSISTS
Has the motor reached full
speed before use?
No
Allow the motor to reach full speed
before use.
Are you using the trimmer cor-
rectly?
?
Only use tip of nylon line to trim.
SEE “How to trim and edge”
Is the line jamming on the spool?
Yes
Rewind the line on the spool, if
symptoms still persist, change
spool and line.
Clean wheel and groove on trimmer head. SEE “MAINTENANCE” WHEEL STOPS TURNING