11
EN
4. Running belt deviation adjustment
All treadmils need to be adjusted before they are shipped from the factory and after they are
installed.However, after a period of time, they may stll run off the track. There may be several
reasons for this phenomenon:
(1) The host is not placed flat;
(2) The user's feet are not in the center of the running belt during exercise;
(3) When the user exercises, the feet are not evenly stressed, which will artificially cause
the running belt to deviate. It can be restored to a normal state after a few minutes of noload
running. For the deviation of the running belt that cannot be automatically restored, you can use
the 6mm wrench in the accessory kit to gradually adjust it in quarters of a circle as the unit. The
running belt deviation does not belong to the range of warranty, and it is mainly up to the user to
maintain and maintain according to the instructions. Deviation will seriously damage the running
belt, and it must be detected and corrected in time.
a.Running belt skidding:When a person is running, the running belt has the phenomenon of
sliding or momentary pause;
b. Adjusting the running belt: Tighten the screws on the left and right sides of the running belt,
turn it clockwise three times, and then adjust according to the deviation direction of the running
bet. If it shifts to the right, adjust the right side; if it shifts to the left, adjust to the left side, until the
running belt is centered.
The running belt shifts to the right,
tighten the right side
Fine adjustment of the left and right
balance
Fine adjustment of the left and right
balance
The running belt shifts to the left,
tighten the left side