User Manual
7
Operation code
Contents
1
Step 1.Pick up phone and press “****” to start IVR
Step 2.Choose “1”, and FTA1101 report the current WAN port
connection type
Step 3.Prompt "Please enter password”, user need to input password
with end char # if user want to configuration WAN port
connection type.
The password in IVR is same as the one of WEB login, user can use
phone keypad to enter password directly, and the matching table is
in Note 4.
For example: WEB login password is “admin”, so password in IVR
is “admin” too, user input “23646” to access and then configuration
WAN connection port.
Step 4.Report “operation successful” if password is right.
Step 5.Choose the new WAN port connection type from 1.DHCP and
2.Static
Step 6.Report “operation successful”, this means user make the changes
successfully, and then FTA1101 will return to sound prompting
“please enter your option, one WAN Port ……”
.
Note: add “#” to assume after input password and selected new
WAN port connection type
If you want to quit by the wayside, press “*”
2
Step 1.Pick up phone and press “****” to start IVR
Step 2.Choose “2”, and FTA1101 report current WAN Port IP Address
Step 3.Input the new WAN port IP address and with the end char #,
using “*” to replace “.”, user can input 192*168*20*168 to set the
new IP address 192.168.20.168
press # key to indicate that you have finished
Step 4.Report “operation successful” if user operation properly.
Note: If you want to quit by the wayside, press “**”.
3
Step 1.Pick up phone and press “****” to start IVR
Step 2.Choose “3”, and FTA1101 report current WAN port subnet mask
Step 3.Input a new WAN port subnet mask and with the end char #
using “*” to replace “.”, user can input 255*255*255*0 to set the
new WAN port subnet mask 255.255.255.0
press # key to indicate that you have finished
3) Report “operation successful” if user operation properly.
Note: If you want to quit by the wayside, press “**”.
4
Step 1.Pick up phone and press “****” to start IVR
Step 2.Choose “4”, and FTA1101 report current gateway
Step 3.Input the new gateway and with the end char #
using “*” to replace “.”, user can input 192*168*20*1 to set the
