19
Adding a knob:
•
1. Using a flathead screwdriver carefully
release the clips holding the plate on the
front. The clips are marked in red in the
picture .
•
2. Carefull remove the cover plate and replace
it with the new coverplate designed to hold 2
knobs.
•
3. Insert the 2 knobs from the back to the
front. Make sure the knobs have the correct
orientation shown in the picture .
Note: First make sure that the plastic knob cover
has been remove, otherwise it will not fit.
Make sure that the wires are layed down beside
the gimbals in order to stop them from catching
on any moving parts.
•
4. Secure the knob by placing the nut on
the threads and tightening. Make sure that
the nut is not too tight as this could lead to
damage to the plastic.
•
5. Place the plastic knob onto the metal rod.
Make sure it lines up correctly, do not force
the knob onto the rod.
