“FLASH 100” OWNER’S MANUAL REL . 2.0
___________________________________________________________________________
©
Copyright by
FLY
Products
s.r.l.
Page
15
3.5 Engine break-in
The engine run in completed after 8 - 10 hour of normal use, use the follow safety advice.
A
- To regulate rich the carburization of the High screw at 1+1/4 turn (screw H).
B
– ONLY for break-in time, use fuel with oil until at 3 – 3.5 % of synthetic oil.
(after break-in, for a normal use the oil in the mixture
never go down
under 2% !)
C
- You not stay accelerated totally if not the time tightly necessary.
D
- You check every times (each 15 - 20 minutes) when the motor is not warm up, the fix of all the
screws.
E
- You avoid the run of motor without propeller.
3.5.1. Coolant
Frequently Check the coolant, the cooler liquid amount have to be:
- About 600 ML in the radiator
- About 100 ML in the small recovery tank
When you need to restore the coolant level, always pour the liquid inside the
radiator and not in the small recovery tank
.
CAUTION
:
Check the liquid in the radiator at least after 6-8 hours of flight.
3.6
Harness Adjustment.
The harness consists of two separate strapping systems, one used to comfortably support the
paramotor assembly unit on the pilot’s back while on the ground, and the other is used to support
the paramotor and pilot while flying. This system also correctly aligns the thrust angle of the prop.
Fig. 24 - Front and Side views of ground handling straps (GREEN)and the flight straps(RED)
