10
Place the sliding covers on the tank.
Peel off the protective film from the two aquarium covers.
1. Lay the narrow cover in the lower sliding surface of the
runners (support rails).
2. Lay the wider cover in the upper sliding surface of the
runners (support rails).
Maintenance
For maximum LED performance, it is recommended that the
fixture and the LED lens be cleaned on a weekly basis. Unplug
the LED driver prior to cleaning the light fixture. Use both hands
when manipulating this appliance. Wipe exposed surfaces
carefully with a damp cloth to remove any dust or mineral
deposits that may collect over time. Do not use detergents or
harsh cleaners as it can damage the light fixture.
Use Fluval LED Lens Cleaning Kit (A3969) to clean the LED portion of the light fixture. Make sure all surfaces are dry before
re-connecting the LED driver to the power source.
Troubleshooting
If the LED Strip Light does not turn on, please proceed as follows:
PROBLEM
CAUSE
SOLUTION
The light isn’t working.
Missing connection of the LED driver to the power
outlet.
Connect the LED driver to the power outlet.
Missing connection of the lighting unit to the LED
driver.
Connect the lighting unit to the LED driver with its
connector.
If the problem is not solved after following the above, please contact your Hagen retailer.
LED STRIP LIGHT AND TANK MAINTENANCE
Cleaning the LED Strip Light
Disconnect the Strip Light from power supply before any maintenance operation.
WARNING: Be sure you unplug the LED driver from the power outlet; just switching off the lights with the APP
is NOT enough because it does not stop the power supply. Never place the LED Strip Light under water jets or
submerge in water.
No special maintenance is required for the Fluval LED Strip Light and covers, other than periodic cleaning with a damp cloth
(never use harsh chemical products or detergents). To remove calcareous deposits, it is recommended to use a mild acid such
as lemon juice, followed by a thorough wipe down with a damp cloth to remove any residue.
Saltwater aquariums
It is commonly known that salt water is far more corrosive, conductive (of electricity) and generally degrades both plastic and
metal parts at an accelerated rate versus fresh water. To minimize salt accumulations on the Fluval Covers and on the LED
Strip Light, it is recommended to take note of the following helpful tips:
1. Make sure filter outputs do not spray above the water surface; position them below the water surface with a slight
downward angle, but still allow for surface movement (contributes to oxygenation).
2. If an air pump must be used, frequent removal of salt deposits will be necessary.
3. Keep the water level as constant as possible (regular top-ups due to evaporation). This is beneficial in providing stable
salinity and will help protect the cover.
4. It is recommended to regularly clean all LED Strip Light components that come into contact with salt water on a weekly
basis. The cleaning should be carried out with a wet cloth (never use harsh chemical products or detergents). Simple
lemon juice may be used to take away salt accumulation. Afterwards, rinse carefully to eliminate every residue of acid.
