60
VIBRONET Installation 06.2016
Cable connections
Instructions for crimping (BNC/ TNC)
Dimensions in mm
• Slide sleeve A onto the cable.
• Use an appropriate tool (e.g. cable stripper VIB 81052 ) to strip the
free cable end as shown in diagram.
Note
Cable layout can be damaged!
During cable stripping the shielding, dielectric or inner conductor can
be damanged!
Perform cable stripping properly. Cut off any damaged sections from
the cable and repeat the procedure.
• Push contact B over the cable inner conductor up to the dielectric.
Use an appropriate tool to crimp it (e.g. crimping tool VIB 81026).
A
16
8
4,5
A
C
Pin
Connector housing
Sleeve
B
A
C
B
Coaxial cable
(RG 58 ; RG 59)
Crimping tool - VIB 81026
• Spread the shielding slightly apart and insert the cable into the
housing C. The shielding must lie over the crimping throat.
• Push sleeve A over the shielding and crimp as close as possible to
housing C.
