Fluke Versiv, User Manual

Page: 213 / 260

Chapter 9: Monitor Optical Power
How to Control the Light Source
199
GPU127.EPS
Figure 82. Light Source Controls for the Main Tester
 Use the buttons to control the output port when you use the
main tester as a light source:

Auto
: In this mode, the output port transmits both
wavelengths. The signal includes identifiers that tell a
CertiFiber Pro or SimpliFiber Pro power meter when to
measure power at each wavelength. Use this mode only
with a CertiFiber Pro or SimpliFiber Pro power meter.

Off
: The output port does not transmit the selected
wavelength.

CW
: The output port transmits a continuous signal at one
wavelength. Use this mode if the power meter is not a
CertiFiber Pro or SimpliFiber Pro meter.
 The laser icon is red when the output port transmits the
wavelength adjacent to the icon.
 When the tester has a CertiFiber Pro Quad module installed, use
this control to select multimode or singlemode wavelengths
A
C
B