Fluke MultiFiber Pro, User Manual

Page: 35 / 68

Memory Functions
25
Note
The source’s auto wavelength function does not
operate when you use
2 kHz mode.
To identify cables, use an MTP/MPO cable to connect the
meter to cable outlets. To identify fibers, use a breakout
cable to connect the meter to single or duplex fiber
outlets.
4 When the meter receives the 2 kHz signal from the
source,
2 kHz shows on the meter.
If you use a breakout cable to connect the meter to an
outlet, the channel indicator on the meter moves to the
channel that is connected to the source. You can also
turn off the
SCAN ALL function on the source, then
change the channel on the source to identify
connections.
Memory Functions
The meter stores the loss or power measurements for up to
250 12-fiber cables. Each record contains the measurement
for one fiber in a 12-fiber cable, for a maximum of 3000
records. For example, records 1 through 12 contain the
measurements for the 12 fibers in one cable and records 13-
24 contain the measurements for the 12 fibers in the next
cable.
If memory is full, the meter shows

and

when you
try to save measurements.
View Records
1 Hold down

for 2.5 seconds, press

to put the
cursor next to VIEW RECORD , then press

.
If no records are saved, dashes show for the record
number and the measurement.
2 To scroll through the measurements for each fiber in a
cable, press
 
or
 
.
To scroll through the measurements for the same fiber
number in each cable, press
 
or
 
to select a
fiber, then hold down
 
or
 
. In this mode, the
record number increases or decreases by 12.
3 To exit the view record mode, press

.
Note
Each record includes the date and time when the
measurement was saved. To see the date and time,
look at the records in LinkWare PC software.