9.
Press the
Bits / Bin
softkey on the primary
Modem Results
screen to
retrieve encoding data from the GM/2 and to display the associated graph.
This graph shows the number of bits encoded at each DMT bin. It is viewed
and operated in the same manner as the 990
ADSL Auto-Test
Bits / Bin
graph. Refer to the 990 Users Guide for details.
If the GM/2 fails to establish a link with the DSLAM, a communications error
message is displayed, and the speaker chirps to signal a failure.
10.
To initiate another connection attempt, press
TEST
again.
11.
To remove GM/2 power or to reset and re-initialize the modem, press
BACK
from the primary
Modem Results
screen.
This returns you to the
Main
menu.
The GM/2 is powered until the DSL Modem Test program is exited, allowing
you to conduct subsequent tests without the initial “booting” delay.
Note
To conserve 990 battery power, limit the time spent in active mode or
connect to the external charger while testing.
12.
To ping the network, press the
Ping
softkey on the secondary
Modem
Results
screen. Then, do the following:
a.
Press the
Setups
softkey.
b.
Enter
Ping Setups
information (see 990DSL Series II Users Guide
for Ping setup details).
c.
Press
TEST
.
Network ping test results are displayed.
13.
After a successful connection, the GM/2 can be used to access the Internet
over the subscriber’s ADSLx line:
a.
Connect the supplied Ethernet cable between the GM/2 ENET jack
and the Ethernet port of a PC.
b.
Access the web via a standard browser program.
