Operating Instructions
XW
Warning
To prevent possible electrical shock, fire, or personal injury:
• When using the Clamp, ensure that your fingers are
behind the protective barrier as shown in Table 1.
• Do not use the Clamp if any part, including the lead and
connector(s), appears to be damaged or if a malfunction
of the instrument is suspected.
• Before using the clamp make sure there is no dust or any
small debris on the closing faces of the jaw.
• Close the jaws gently and avoid closing them with high-
impact. The force of the impact can affect the accuracy of
the measurement.
Turn on the Clamp
Push
+
for 2 seconds to turn on/off the clamp.
•
Green LED indicates the Clamp is ON and the battery is ok.
•
Orange LED indicates the battery is lower than 2.2 V.
•
Red LED indicates the battery is lower than 2 V. Replace the
battery before doing a measurement.
P
Conforms to European Union directives.
Conforms to relevant Australian Safety and EMC
standards.
Conforms to relevant South Korean EMC Standards.
Measurement Category III is applicable to test and
measuring circuits connected to the distribution part of
the building’s low-voltage MAINS installation.
Measurement Category IV is applicable to test and
measuring circuits connected at the source of the
building’s low-voltage MAINS installation.
~
This product complies with the WEEE Directive marking
requirements. The affixed label indicates that you must
not discard this electrical/electronic product in domestic
household waste. Product Category: With reference to
the equipment types in the WEEE Directive Annex I, this
product is classed as category 9 "Monitoring and
Control Instrumentation" product. Do not dispose of this
product as unsorted municipal waste.
Table 2. Symbols (Continued)
Symbol
Definition
