28
576
Troubleshooting
Symptom
Display Code
Problem
Action
Camera cannot
Driver installation
Open
send photos
failed
Harware Manager on
to the PC
the PC to fix it
-O-
Target temperature is over
Select target
-U-
or under range
within unit’s specs
EEPROM-Err
EEPROM error
Contact Factory
CalAreaErr
calibration errors
Contact Factory
ProbCalEr
Flash needs
Battery is low
Replace Batteries
too long to
charge or does not
charge at all
Blank display
Battery is dead
Replace Batteries
Laser won’t
Low or dead battery
Replace Batteries
work
Ambient above 45°C (113°F)
Operate unit in
45°C (113°F)
ambient or below
Display “ON”
Display locked “ON”
Disconnect the unit
from the PC
Photos lost
Batteries changed before
Wait for shutdown
shutdown or too long
to end. (blank screen)
after removing old ones
Change batteries within
two minutes of
removing old ones
PC displays “logger The setup in the unit and
Click “OK”. Either save
file does not match
in the PC software do not
the current data to a
device logger setup” match
new file name or find
the correct *.lgg file,
open it in “Setup
Device Logger”, save,
and redownload the
data with the “Data
Logger/Load Device
Data Logger”
Sometimes a long beep and the red LED above
the display shines to indicate a problem, check
your display to find out which problem has
occured.
