Power-Up Configuration
37
E
+
O
Power-Up Configuration
The Tester has two types of configurations: standard and power-up. The
standard configuration, which is programmed into the Tester and can always
be retrieved, includes the following settings:
•
FCN V
Volts Function selected.
•
DISP WAVE
Waveform Screen Mode selected.
•
THD %RMS
Total Harmonic Distortion computed as percentage of
the total RMS value.
•
CLAMP 80I-500S
The 80i-500s Current Probe is selected.
OTHER
specifies any current probe other than the 80i-500s. The Tester
has been calibrated to provide either compensation for the 80i-500s or a
flat response for other probes.
•
P
REF V
Voltage Phase Reference selected.
For Model 41B,
KBAUD 9.6
is the standard configuration for Print or Send,
and
EPSON
is the standard configuration. The Tester always selects
autoranging at power-up.
The power-up configuration, which is initially the same as the standard
configuration, can be changed by making entries from the configuration
screen. The Tester sets up to the power-up configuration each time it is turned
on. You can change the power-up configuration using the following
procedure:
1.
Press
E
while pressing
O
to turn the Tester on. The configuration
screen appears. (See Figure 17.)
2.
Press
<
and
>
to highlight different items on the same line. Press
E
to select the currently highlighted item and proceed to the next
line.
Summary of Contents for 39
