12 Multimeter
Users Manual
14
Use
i
only on power supplies and other power sources that have a low output
impedance. Do not use
i
to measure voltage in electronic circuitry unless a 2 k
e
load will not damage the circuit. See † on page 27.
DISABLING
i
WITH FUNCTION LOCK
To lock the meter in either the continuity/diode or ohms function, and disable
i
:
1. Put the slide-switch in the continuity/ohms position. The meter selects the
continuity/diode or ohms function. Press [
g
] to toggle between the
continuity/diode and ohms functions.
2. Press
[
Z
] to put the meter in manual range.
Z
is displayed. The meter is locked in
the selected function and
i
is disabled.
In continuity/diode test, press [
Z
] to toggle the beeper on and off.
In ohms, press [
Z
] to manually select a range.
To remove the function lock and reenable
i
, press [
Z
] for 2 seconds, press [
g
],
or move the slide-switch.
Summary of Contents for 12
