Fluke Calibration 7526A, Getting Started

Page: 10 / 30

7526A
Getting Started
2
Safety Information
A Warning identifies conditions and procedures that are dangerous to the user; A
Caution identifies conditions and procedures that could cause Product damage,
equipment under test damage, or permanent loss of data.
 Warnings
To prevent possible electrical shock, fire, or personal injury:
•
Read all safety Information before you use the Product.
•
Carefully read all instructions.
•
Use the Product only as specified, or the protection
supplied by the Product can be compromised.
•
Use this Product indoors only.
•
Examine the case before you use the Product. Look for
cracks or missing plastic. Carefully look at the insulation
around the terminals.
•
Use only the mains power cord and connector approved for
the voltage and plug configuration in your country and rated
for the Product.
•
Replace the mains power cord if the insulation is damaged
or if the insulation shows signs of wear.
•
Make sure the ground conductor in the mains power cord is
connected to a protective earth ground. Disruption of the
protective earth could put voltage on the chassis that could
cause death.
•
Do not put the Product where access to the mains power
cord is blocked.
•
Do not touch voltages > 30 V ac rms, 42 V ac peak, or 60 V
dc.
•
Use only cables with correct voltage ratings.
•
Do not apply more than the rated voltage, between the
terminals or between each terminal and earth ground.
•
Do not use the Product around explosive gas, vapor, or in
damp or wet environments.
•
Remove all probes, test leads, and accessories that are not
necessary for the measurement.
•
Do not use the Product if it operates incorrectly.
•
Do not use and disable the Product if it is damaged.