fluidra 74148, Owner'S Manual

Page: 23 / 222

19
6.2.1 button
Press to start the heat pump unit, the LED display shows the desired water temperature for 5 seconds, then shows the
inlet water temperature and the operation mode.
Press to stop the heat pump unit and show “OFF”
Notice : During the parameter checking and setting, press the to quick-exit and save the current setting .
Press again to turn on/off the machine.
6.2.2 and button
Clock/unclock the display:
Hold and for 5 seconds to lock/Unlock the display.
Water temperature setting :
Press
or
to set the water temperature directly.
Water temp. setting range in Heating mode :6-41
℃
,
6.2.3 button
Parameter checking :
Press first, then press to check the “ User parameter from d0 to d11
Code Condition Scope Remark
d0 IPM mould temperature
0-120
℃
Real testing value
d1 Inlet water temp.
-9
℃～
99
℃
Real testing value
d2 Outlet water temp. -9
℃～
99
℃
Real testing value
d3 Ambient temp.
-30
℃～
70
℃
Real testing value
d4 Frequency limitation code 0,1,2,4,8,16 Real testing value
d5 Piping temp.
-30
℃～
70
℃
Real testing value
d6 Gas exhaust temperature 0
℃～
C5
℃
(125
℃
) Real testing value
d7 Step of EEV
0
～
99
N*5
d8 Compressor running frequency
0
～
99Hz
Real testing value
d9 Compressor current
0
～
30A
Real testing value
d10 Current fan speed 0-1200
（
rpm
）
Real testing value
d11 Error code for last time All error code
Press first, then press to check the “ User parameter from P0 to P7
If needed, press second, then press or to adjust the current parameter.
(for example: Press first, then press to enter parameter P7 checking, and press second, then press
or to adjust the parameter P7 Inlet water temp. Correction from -9 to 9.)