• The device's maximum Ethernet capacity and current
Ethernet throughput are shown. This allows you to monitor
Ethernet utilization and determine whether the Ethernet
port is overutilized (particularly if the Fluid Throttle plug-in
is installed).
• If a Fluidmesh device is not performing as expected, the
dot representing the unit turns yellow. If a yellow dot is
clicked, the warning details for the unit will be shown.
4.
All static Fluidmesh devices represented by dots can be placed in
any position on the map view. To move any dot, click-and-drag
the dot to the needed position.
5.
To save the network layout currently seen on the map view, click
the
Save Layout
button.
6.
If the positions of any device dots have been changed and the
Save Layout
button has not yet been clicked, you can restore the
visual network layout to its last saved configuration by clicking the
Load Layout
button.
Using the Vehicles table
The Vehicles table is found at the lower edge of the window. A typical
example is shown in (
Figure 42. Fluidity Quadro (Vehicles table)
To use the
Vehicles
table, do the following steps:
1.
Expand the table by clicking the
+
button at the upper right-hand
corner of the table.
Fluidmesh 4200 FIBER
© Fluidmesh Networks LLC
Page 92 of 180