•
Click the
-snmp
mode link under
ADVANCED SETTINGS
in the
left-hand settings menu.
• The default
SNMP
).
Figure 57. SNMP dialog (SNMP disabled)
NOTE
By default, Fluidmesh units are shipped from the
factory with SNMP disabled.
Using SNMP v2c
To change the unit's SNMP mode to
v2c
and configure the unit
accordingly, do the following steps:
1.
Click the
SNMP mode
drop-down, and click the
v2c
option.
• The
SNMP
v2c settings dialog will be shown (
).
Figure 58. SNMP dialog (v2c selected)
2.
Enter a community identity value in the
Community ID:
field.
Fluidmesh 4200 FIBER
© Fluidmesh Networks LLC
Page 111 of 180