6.6.3. Static routes
The Static routes window is used to set static routing rules (in other
words, manually-configured routing entries, as opposed to routing
instructions from a dynamic routing table) for a Fluidmesh unit.
Static routes are typically used if there is a need to do any of the following
in context of the network:
• Access a remote subnet that does not belong to a local network
• Access other Fluidmesh radio units or client devices across the
local network
• Reach gateways (such as Internet gateways)
• Create networks that include 'fixed' devices (such as CCTV
cameras)
To change the Static Routes settings, click the
-static routes
link under
ADVANCED SETTINGS
in the left-hand settings menu.
• The
Static Routes
dialog will be shown (
Figure 49. Configurator GUI (Static Routes window)
To enter a new static route, do the following steps:
1.
Enter the
Subnet
,
Netmask
and
Gateway
designators in the
correct fields of the
Add new static route
section.
2.
Click the
add
button.
• If the new static route is valid, it will be added to the
Active
static routes
list.
Fluidmesh 4200 FIBER
© Fluidmesh Networks LLC
Page 103 of 180