GUIDE TO SELECTION
Note:
Conformal coating is available as optional. It is suggested in
application where there is huge changes of ambient temperature
and risk of condensation.
Warning
The safety requirements of the TMFR/TSFR device in operation
require the installation and the startup to be made by technicians
certified by Fluid-o-Tech, in accordance with the general safety
regulation valid when working with current and voltage dangerous
for people’s health.
ELECTRICAL CONNECTIONS
Power supply
single-phase 230V/115V tolerance ±10% freq. 50/60 Hz
Controller type
Trapezoidal 3 Phase - U/V/W
Motor type
BLDC 3 Phase
voltage
180 Vac three-phase star (wye) measurement
Output
frequency
from 30 to 120 Hz (freq. PWM 15 KHz)
current
Continuous output = at nominal current
operating temperature:
0 °C to 40 °C (measured in close proximity to the inverter)
storage temperature:
-20 °C to +60 °C
Environment conditions
ventilation:
natural circulation
humidity:
from 20% to 90% without condensation
altitude of installation:
max. 2000 m u.s.l. (derating for higher altitudes)
protection:
IP 20
Type External connections
Digital opto-coupled
LED (orange):
Indication of Supply (permanent) / Alarms (blink).
Alerts
Is located in the center of the main board.
Digital output at pin 5:
0V active
electronic protections:
over-voltage; under-voltage; over-temperature driver;
over-current driver; motor blockage for pump locked rotor
Protections
motor protection:
over-heating
in-rush current:
limited by NTC component rated 2.5 Ohm
L PE
SUPPLY CONNECTOR
PHOENIX 1700008 X3
+ 1700024 X 1
OR EQUIVALENT
OUT MOTOR CONNECTOR
PHOENIX IC 2,5/4-G-5,08
OR EQUIVALENT
SERVICE CONNECTOR
ON BOARD TYCO 640457
OR EQUIVALENT
pin1
N
PE W V U
SUPPLY CONNECTOR
PHOENIX 1700008 X3 + 1700024 X 1
OR EQUIVALENT
L PE N
TO OUT MOTOR
MOTOR CABLE
CONNECTOR
TO PUMP
PHOENIX IC 2,5/4-ST-5,08 or equivalent
PE
W
V
U
Overview power terminal board
CONTROLLER
MOTOR TYPE
PUMPS
COMPLIANCE
FEE2AWR1
115 vAC ul
FEE2DWR1
32-35-01
TMFR/TSFR
230 vAC ul
FEE2EWR1
230 vAC ce
Summary of Contents for TMFE2
Page 10: ......
