/ 13 /
INSERTING THE GRAPHICS CARD INTO THE CHASSIS
If necessary, temporarily remove the water block to check for uniform surface
contact between the block and components. Pay special attention to the
VRM section of the graphics card. Check whether the water block makes
contact with the intended integrated circuit. Then repeat Steps from the
previous section to re-attach the block.
In case you fail to obtain good contact, please check again or
contact our support service at
https://www.ekwb.com/customer-support/.
CHECKING THE CONTACT IN CASE OF HIGH TEMPERATURES
Carefully lift your graphics card with the installed water block and insert it into
your PC’s motherboard PCIexpress expansion slot. Please keep in mind that
your graphics card is heavier than before it was equipped with the water block.
You need to be very careful when handling the graphics card.
Avoid all unnecessary manipulation of the water block assembly
that might damage your card or water block..
