/ 10 /
INSTALLING THE WATER BLOCK
For this Step, you will need:
M 2.5 PVC Washer
(14 pcs)
M2.5 x 4 AX1
Screw (15 pcs)
Phillips Head
Screwdriver
STEP 1
PLACING THE BLOCK ON THE GRAPHICS CARD
This procedure is the same for all full-cover water blocks.
Carefully position the water block with preinstalled standoffs on the graphics
card. During this process, make sure you have aligned mounting holes of the
PCB with holes of the water block (same applies to other tops).
Pay attention not to use too much force when pressing the block
down to the PCB since chip dies are prone to cracking.
4 mm
M2.5 x 4 AX1
PVC WASHER
WITHOUT PVC
WASHER
STEP 2
ATTACHING THE WATER BLOCK
Use fifteen (15) M2.5 x 4 AX1 screws and fourteen (14) M2.5 PVC washers.
Tighten the screws evenly using the Phillips head screwdriver. EK recommends
you start tightening the screws around the GPU core first and then continuing
outward to prevent damage to the GPU.
STEP 2
STEP 1
