WT675 Wet-Tap Insertion Assembly
2
3.
Thread body assembly into 1” full-port ball-valve (user supplied). Be sure and seal
threads with Teflon tape or paste.
4. Install electrode into rod assembly by pushing electrode large end of rod and rotate to
align connector. After engaging connectors, rotate 1/4 run to lock electrode in place.
5. Insert rod into body assembly until o-ring face seal seals against body. Then slide
white nut over rod from back side and tighten onto body.
6. Open ball valve then loosen hex nut and push rod into desired position. Tighten nut to
hold position.