• Start by dry fitting the two base components
following the engraved arrows labelled 1.
• Partially screw in the two sides (arrows
labelled 2 and 3), taking care not to fully
tighten yet.
• Dry fit the lower rear and upper rear wall, not
fully tightening at this point.
• Screw in the front gable. Now tighten all
screws (do not over-tighten).
• Finally assemble the roof.
• Then add the tubes and wooden rods.
• You can then fill the roof cavity with local
materials such as leaves, straw, grass or even
a little mud before attaching the shingles.
• Finally fix your pollinator house in place in a
stable and secure location.
The bamboo tubes and timber
rods come loose-packed so
you can get creative with
the placement (children love
being involved in this!). It is
important that the tubes are
tightly packed so they don’t
fall out, however it’s best not
to glue them just in case you
need to remove them for
cleaning or care.
1 x front gable
2 x side walls
1 x rear wall
1 x base
2 x shingles
1 x ridge cap
Rods and
tubes
PARTS
ASSEMBLY
HARDWARE
22 x
38mm 8G
eco coated
screws
1 x
longer
screw for
hanging
Assembly tool &
Square bit drive
Sandpaper
FLOW POLLINATOR ASSEMBLY
TIP: You may
wish to pre-
drill pilot holes
to reduce the
risk of wood
splitting.
Please visit www.honeyflow.com for
more helpful tips and links on assembly.