5
L100235 - Autojet & Multimax Owner’s manual | Copyright© Pentair Australia Pty Ltd 2017
Installation
We strongly recommend this product be installed by a suitably
qualified person.
The electrical installation shall be in accordance with the national
wiring rules (AS/NZS 3000) for class 1, IPX4 rated products.
These instructions are a guide only. Users not familiar with pumping
equipment should seek advice from people experienced in pump
equipment and installation.
Freezing conditions will damage the unit, because when water
freezes it expands. Ensure that the pump is located so that it is not
prone to freezing, or ensure that the product is disconnected and
dried of water during cold conditions.
AJ & MM pumps are electrically connected. Ensure that they are
switched off and unplugged from socket outlet during installation
and any subsequent service work.
The pump is designed to be used with clean water in a residential
application. Do not use it with alternative fluids, abrasive, corrosive
or explosive fluids. Do not install or operate your pump in an
explosive environment or near combustible matter.
Incorrectly installed or tested equipment may fail, causing severe
injury or property damage.
Fire and burn hazard. Modern motors run at high temperatures. To
reduce risk of fire, do not allow leaves, debris, or foreign matter to
collect around the pump motor. To avoid burns when handling the
motor, let it cool for at least 20 minutes before trying to work on
it. Automatic thermal overload cut-out protects the motor for heat
damage during operation and it will restart without notice when the
motor cools down.
The pump is not intended for use by young children or infirm persons
without supervision. Young children should be supervised to ensure
that they do not play with the pump.
Read the following instructions in this owner’s manual when installing and operating
equipment.
