11
GB IE
housing and become stuck, by using a
jet of water.
• Clean any deposits adhering to the
floating switch ( 5) with clean water.
Cleaning the filter
In the suction foot, the pump has a remov-
able filter, designed to protect it from dirt.
According to the level of dirt in the water,
this should from time to time be checked
and cleaned when necessary.
1. Unplug the appliance from the
power supply.
2. Remove the five screws on the un-
derneath of the pump housing (9).
3. Take the suction foot (8) off the
pump and take out the filter (7).
4. Wash the filter (7) under running
water and put it back in place.
5. Put the suction foot (8) back on
the pump and fasten it with the
five screws.
Cleaning the impeller wheel
If deposits in the pump housing become
too heavy, the bottom part of the pump
must be dismantled as follows.
1. Remove the 5 screws on the bottom of
the pump casing and pull off the suc-
tion foot ( 8).
2. Unscrew the paddle wheel cover (
24) (6 screws).
3. Clean the inside wall of the pump
housing and the impeller wheel with
clear water.
4. For re-assembly, follow the same
steps in reverse.
Storage
• Store the appliance in a dry, frost-free
place, and where children cannot gain
access to it.
• When the pump is not to be used for
a longer period, it must be thoroughly
cleaned after its last use, and before it
is next used. Otherwise there may be
problems in starting the pump, caused
by deposits and residues.
- Wind the mains cable (12)
around the cable storage area
( 10).
- Insert the dismantled aluminium
tube (13/14/15/19) into the stor-
age compartment (3).
All other work on the pump, and in particular
opening it, must be carried out by a special-
ist electrical service engineer. If any repairs
are necessary, you should always get in
touch with the Grizzly Service Centre.
Waste disposal and envi-
ronmental protection
Be environmental. Return the tool, acces-
sories and packaging to a recycling centre
when you are finished with them.
Machines do not belong with do-
mestic waste.
Hand over the device at an utilization
location. The plastic and metal parts em-
ployed can be separated out into pure
materials and recycling can be implement-
ed. Ask your Service Center (see Page 16)
about this.
Defective units returned to us will be dis-
posed of for free.