FLORABEST FAHE 20-Li A1, Translation Of The Original Instructions

Page: 33 / 136

FAHE 20-Li A1 ■ 30 │
GB
│
IE
Fixing/attaching the shoulder strap
♦ Hook the shoulder strap into the carrying
lug .
♦ Adjust the length of the shoulder strap to
your size so that carrying lug is at hip height
when hooked in place.
♦ In addition, you can adjust the height of the
carrying lug on the appliance shaft by
loosening the screw.
Mounting the saw chain and blade
WARNING!
► Wear protective gloves! There is a danger
of injury from the sharp cutting teeth!
► The sprocket cover together with the chain
tensioning ring and the fixing screw
are not pre-assembled on the appliance at
delivery.
► The turning of the blade is not intended by
the manufacturer.
► The chain travel direction on the blade
must be adhered to every assembly.
♦ Place the saw chain in the blade groove.
Ensure that
the saw chain is running in
the correct direction.
♦ Attach the blade with the labelling facing
upwards and guide the saw chain around
the chain sprocket .
The guide rail must be above the blade
guide .
♦ Put the sprocket cover on.
♦ Tighten the fixing screw slightly.
♦ Now, tighten the saw chain (see section
Tightening and checking the saw chain).
♦ Tighten the fixing screw completely.
Tightening and checking the saw
chain
WARNING!
► Wear protective gloves! There is a danger of
injury from the sharp cutting teeth!
♦ Undo the fixing screw .
♦ Turn the chain tensioning ring in a clockwise
direction to increase the tension.
♦ The saw chain must lie against the underside
of the blade.
Check whether the saw chain can be drawn
over the blade by hand .
♦ Now tighten the fixing screw completely.
NOTE
► A new saw chain stretches and must be
tightened more regularly.
Lubricating the chain
♦ Remove the oil filler cap .
♦ Fill the oil tank with approx. 65 ml of organic
chain oil .
WARNING!
► Never work without chain lubrication!
If the saw chain runs dry, the cutting
equipment may become irreparably dam-
aged within a short time. Always check chain
lubrication and oil level in the tank before
starting work.
NOTE
► Use only saw chain oil. Preferably biodegrad-
able. Do not use waste oil, motor oil, etc.
► While working, check whether the automatic
chain lubrication is working correctly. Check
the chain lubricator before and during work.
Sharpening the saw chain
NOTE
► You will find detailed information on
sharpening in the sharpening set, e.g. from
Oregon.
► Alternatively, you can use an electrical saw
chain sharpening device and follow the
instructions of the manufacturer.
► If you have any doubts about implementing the
work, the saw chain should be replaced.