FLORABEST 296736, Assembly And Safety Advice, Page: 15 / 57

15 GB/IE
Figure A:
Spread out the sun shade sail
1
in front of the assembly site and
use a measuring tape to trans-
fer the length of the sun shade
sail
1
to the wall on which it
will be mounted.
Mark the positions for the ring
bolts (not included in the scope
of delivery) on the wall and
mount these.
Tighten the ring bolts using a
pair of pliers.
Figure B:
Cut the tensioning cable
2
into
several parts. Ensure that the
length of the individual parts is
enough to be able to knot them.
Figure C:
Now thread one end of the ten-
sioning cable parts through a
loop of the sun shade sail
1
.
Tie the tensioning cable parts
into a tight knot.
Thread the other end of the ten-
sioning cable parts through a
spring
3
and tie a tight knot.
Attach a snap hook
4
to the
other end of each spring
3
.
Figure D:
Now hang the sun shade sail
1
from the wall. To do so, con-
nect the individual ring bolts to
a snap hook
4
.
Figure E:
Attach the loose end (Models A
and B) or both of the loose sides
(Models C and D) of the sun
shade sail
1
to a suitable loca-
tion such as a tree trunk.
Dismantling the product
Disassemble the product in the
reverse order.
Cleaning
Never wash the sun shade sail
in a washing machine.
Do not use any sharp objects as
these will damage the coating.
Remove dirt from the sun shade
sail with a soft sponge and
clean water.
Allow all parts dry thoroughly
before you pack the sun shade
sail away again. This will pre-
vent mould, odours and colour
changes.