17
GB/IE/NI
Installation on a wall using a screw / peg
Use the enclosed peg
18
(Ø 6 mm) and the screw
17
to install
the product on a wall. This installation material is intended for a
normal wall. If the wall you wish to install the product on has a
different consistency, check with a specialist to find out which
material is suitable for installation on your wall.
Ensure the screw
17
is a maximum of 1.5 m above the ground.
Allow the screw to protrude approx. 1 cm from the wall and
use the loop
7
to hang the product on the screw.
Operation
The product has two adjustment options:
Adjusting the motion sensor
The sensitivity of the sensor can be adjusted using the sensitivity con-
troller
2
. If a movement is detected, a signal / flash sounds /
shines approx. 30 sec. Adjust to MAX position, the detection
range approx. 8 m.
Adjusting the signal frequency
The product has 5 different programmes to repel certain kinds of
animals.
