Flomec QSI Series, Installation Instructions Manual

Page: 5 / 20

5
ASSEMBLY INSTRUCTIONS
4. Using a small regular screwdriver,
remove the clear sealant from the
10 pin female connector holes on
the backside of your display.
5. Insert the “long legs” of the 10 pin
male connector that came with
the kit into the 10 pin female
connector on the QSI circuit
board (see Figure 2).
6. Install the formed display seal into
the seal gland on the backside of
the display.
7. CAREFULLY mount the display
onto the cover plate ensuring the
legs of the male 10 pin connector
are inserted into ALL 10 pin
female connector holes of the
display (see Figure 3).
8. Secure the display to the
cover plate using the four
#4-20 x 7/8 in. tapping
screws. Torque to 80-96 oz-in
(0.56-0.67 Nm).
NOTE:
For
Display Ready
QSI
Modules Only.
For the “Display Ready” QSI module,
follow these initial instructions first
to install your customer provided
display to the cover plate in the
kit. Then follow the Installation
Instructions to install this customer
assembled unit to the meter.
1. Make sure the QSI module is
disconnected from power source.
2. Remove batteries from your
display, they will no longer be
needed.
3. Remove the pickup coil from the
back center of your display by
cutting the two wires that attach
it to the display. Cut the wires as
close to the display as possible to
ensure the cut ends do not touch
the PC board inside the QSI
module. Discard the
removed coil.
Figure 3
Figure 2
COIL & BATTERIES REMOVED
#4-20 X 7/8 IN.
TAPPING SCREW
CUSTOMER
PROVIDED DISPLAY
10 PIN MALE
CONNECTOR
10 PIN FEMALE
CONNECTOR
QSI CIRCUIT
BOARD
DISPLAY SEAL
10 PIN FEMALE CONNECTOR
(DISPLAY)
10 PIN MALE CONNECTOR (SHOWN
SEATED IN DISPLAY CONNECTOR)