STEP 1
Remove the shipping plugs from the Quad pump ports.
Some water from factory testing may spill out.
STEP 2
Install both the A. inlet and B. outlet port adapters as
shown in the figure above or install strainer on inlet A.
Firmly push C. slide clips forward to lock adapters in place.
STEP 3
Push the 4 rubber grommets into base plate mounting
holes, where a base plate is used.
STEP 4
Mount pump horizontally, or vertically with the pump-
head lower than the motor. Any plumbing leak should
not drip on the motor.
STEP 5
3/4" I.D. hose may be used (preferably braided or
reinforced) to isolate pump from plumbing system.
1/2" I.D. hose may be used on 3.5 GPM model. Use
hose clamps on hose barb connectors.
STEP 6 (OPTION)
Install a 40 mesh in-line strainer in an accessible location
between the supply and the pump inlet A.
INSTALLATION
The Automatic Variable Speed Motor Driven Pumps will
operate in either a 12 or 24 volt dc system. The unique
electronics adjust the voltage and current to the motor as
needed.
STEP 1
Use 14 AWG stranded wire to 20 feet, 12 AWG to 50 feet
from distribution panel or power source.
STEP 2
Install a 15 amp rated on-off switch on the positive (+)
lead from the power source.
STEP 3
Use a 15A fuse/breaker in the circuit at the distribution
panel.
WIRING
Red (+)
(+)
Switch
EMI
Filter Box
15 Amp
Automotive
Fuse Inside
Battery
(–)
Black (–)
City Water
Inlet
Water
Tank
Check
Valve
Do Not Plumb Autofill
to Pump Suction Line
Water
Heater
Flojet Inlet
Strainer
Autofill Tank Valve,
Plumb to Tank
B
A
C
