3
PLUMBING INSTALLATION
PLUMBING
The Bottled Water Dispensing System may
also be placed in a pantry, closet, cellar or
other location where a grounded electrical
outlet is available.
Insert suction hose port
fitting into pump module
“IN” port and slide locking
port clip in place.
Insert DC plug/connector into pump module “DC IN” port.
The connections for the float and power supply will require
moderate force to insert fully. This is a design feature
that assures the connections are held securely after initial
installation. MAKE SURE PLUG / CONNECTOR IS INSERTED
ALL THE WAY INTO THE CONNECTIONS. FAILURE TO
INSERT FULLY WILL LEAD TO POOR OPERATION OR NO
OPERATION.
To install tube into
“OUT” port. Push
1/4” discharge
tubing all the way
into quick
connect port
(as far as it will go)
To remove tube from “OUT” port:
1.
Push tube all the way in
2.
Hold gray ring against black
port with finger or flat tool
3.
Pull tube out
Push clip up to lock
Insert float sensor switch plug/connector into pump
module “SWITCH” port.
The connections for the float and power supply
will require moderate force to insert fully. This
is a design feature that assures the connections
are held securely after initial installation. MAKE
SURE PLUG / CONNECTOR IS INSERTED ALL THE
WAY INTO THE CONNECTIONS. FAILURE TO
INSERT FULLY WILL LEAD TO POOR OPERATION
OR NO OPERATION.
Select a cabinet large enough to accommodate the 5 gallon (19L) bottle and suction wand assembly. Place the
pump module on the floor of the cabinet with on/off switch and suction tube facing out toward the cabinet doors.
Position as close as possible to a
grounded electrical outlet and
place the five gallon bottle close to
the pump module without kinking the
suction hose.
