4
INSTALLATION
STEP 1
-ATTACHING PANEL(S)
ATTACH THE PANEL(S) TO THE UPPER MOUNT WITH PHMS #10-32 x 5/8” SCREWS,
#10 WASHERS, AND 10-32 NYLOCK NUTS (4 FOR 12V SYSTEMS, 8 FOR 24V
SYSTEMS). TIGHTEN UNTIL BOLT HAS NO FREE PLAY. DISCONNECT HARNESS(ES)
(LONGER JACKETED WIRES) FROM SOLAR PANEL CONTROLLERS, THEN PUSH
PANEL WIRE(S) (SHORTER WIRES) THROUGH THE PLUG(S) IN THE UPPER MOUNT.
STEP 2
-WIRE FEEDING
TAKE THE DISCONNECTED HARNESS(ES) AND FEED THEM THROUGH THE MAST.
RE-CONNECT THE HARNESS TO THE PANEL CONNECTOR.
INSTALL THE SOLAR PANEL
CONTROLLERS AT OPPOSITE
CORNERS SO THAT THE WIRES ON
EACH CONTROLLER REACH THE
GROMMET ON THE SIDE NEAREST
TO THE CONTROLLER
