Flo Home G5, Installation Manual

Page: 9 / 36

9
FLO Home G5 | Installation guide | flo.com | September 2018
FL
O.IG.G5HOME.09.2018.v2
- © 2018 Ser
vices FL
O USA Inc. All Rights Reser
ved.
7
Connect the two power wires (L1 and L2) and the
ground wire (GND).
8
Install the front housing of the charging station:
A) Hang the top by presenting the front housing at an
angle of about 30 degrees, then pivot vertically
without forcing.
B) Tighten the 2 front screws with a nominal torque of
55 lbs-in.
L1
L2
GND
Detail A
About
30°
A
B
Nominal torque for conductors:
L1-L2: 6 AWG = 16 lbs-in
8 AWG = 16 lbs-in
GND: 6 AWG = 45 lbs-in
8 AWG = 40 lbs-in
9
Switch on the electrical circuit breaker.
Your new station can now charge your vehicle!
W
arNiNg
: Always use a manual
screwdriver; DO NOT use an Impact
Driver for the station screws, in which
case the warranty would no longer be
valid.