Flo Home G5, Installation Manual

Page: 13 / 36

13
FLO Home G5 | Installation guide | flo.com | September 2018
FL
O.IG.G5HOME.09.2018.v2
- © 2018 Ser
vices FL
O USA Inc. All Rights Reser
ved.
IC statement: CAN ICES-3 (B)/NMB-3 (B)
This device complies with Industry Canada and USA licence-exempt RSS standard(s)
Operation is subject to the following two conditions: (1) this device may not cause
interference, and (2) this device must accept any interference, including interference
that may cause undesired operation of the device.
FCC statement (for USA only)
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation. This equipment has been tested and found to comply with
the limits for a Class B digital device. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the
following measures: Reorient or relocate the receiving antenna; Increase the
separation between the equipment and receiver; Connect the equipment into an outlet
on a circuit different from that to which the receiver is connected; Consult the dealer
or an experienced radio/television technician for help.
Compliance with safety standards
- Meets applicable UL safety standards. Certified by CSA Group, a Nationally
Recognized Testing Laboratory (NRTL).
- CSA C22.2 No. 0-10 General Requirements – Canadian Electrical code, part II.
- CSA C22.2 No. 281.1-12/UL2231-1 Standard for safety for personnel protection
systems for electrical vehicle (EV) supply circuits: General requirements.
- CSA C22.2 No. 281.2-12/UL2231-2 Standard for safety for personnel protection
systems for electric vehicle (EV) supply circuits: Particular requirements for
protection devices for use in charging systems.
- CSA C22.2 No. 280-13/UL2594 (1st edition) Electric vehicle supply
equipment (EVSE).
- CSA C22.2 No. 0.8-12 Safety functions incorporating electronic technology.
- UL1998 Standard for software in programmable components.
- UL991 Standard for Tests for Safety-Related Controls Employing
Solid-State Devices.
- NEC 2014 section 625.
Compliance
254081