FLIR Screen-EST Kiosk, User Manual, Page: 17 / 58

Setup — Screening station
6
This chapter describes how to set up a FLIR Screen-EST Kiosk screening station.
• For accurate and efficient screening, it is recommended to set up the screening sta-
tion as outlined in section 6.1 Screening station setup .
• For step-by-step instructions, see section 6.3 Step-by-step setup instructions .
• If you run into problems, see section 6.5 Trouble shooting .
6.1 Screening station setup
The figure below shows a typical screening station setup. For more information, see
chapter 7
Description — Screening station .
1. FLIR Screen-EST Kiosk.
2. Screening position.
It is important to clearly mark the screening position (where the person should stand
for the screening). The distance from the foot of the FLIR Screen-EST Kiosk to the
center of the screening position shall be 120 cm (47 in.).
3. Queueing system, e.g. barriers and arrow floor stickers.
The queueing system will guide the visitors into the screening station, to the correct
screening position, and out of the screening station. A recommended standard is to
keep the queue at least 90 cm (36 in.) wide. To make sure people do not cut the cor-
ner and end up too close to the FLIR Screen-EST Kiosk, about 45 cm (18 in.) should
be added to the barrier leading in to the screening station.
4. Optional: Backdrop.
A backdrop may be needed to prevent background disturbances from reaching the
camera, such as passing or queueing people.
Additional, not in the figure:
• Optional: Operator display.
Secondary display placed near the operator for monitoring.
• Optional: Information roll-up.
Roll-up that informs people what the screening is about and why they need to do it.
• Optional: Instruction roll-up.
Roll-up that tells people to remove eyeglasses before they are screened.
Note Removing eyeglasses is crucial for a correct screening result.
#T810570; r. AA/72255/72255; en-US 13