Document Scope and Purpose
CB-640x Installation and User Guide Revision 100
February 2021
4
This document does not contain any export-controlled information.
Warning
•
Do not drop the camera or subject it to physical shock.
•
Do not touch sensor modules with fingers. If cleaning is necessary, use a clean cloth with a
bit of ethanol and wipe it gently. If the camera will not be used for an extended period of time,
put on the lens cap to protect the sensor from dirt.
•
Do not aim the camera lens at strong light, such as the sun or an incandescent lamp, which
can seriously damage the camera.
•
Make sure that the surface of the sensor is not exposed to a laser beam, which could burn
out the sensor.
•
If the camera will be fixed to a ceiling, verify that the ceiling can support more than 50
newtons (50-N) of gravity, or over three times the camera’s weight.
•
The camera should be packed in its original packing if it is reshipped.
Caution
To avoid damage from overheating or unit failure, assure that there is sufficient temperature
regulation to support the unit’s requirements (cooling/heating). Operating temperature should be kept
in the range -40°C to 60°C (-40°F to 140°F) cold start, with no more than 95% non-condensing
humidity.
Attention
Afin d'éviter tout dommage dû à une surchauffe ou toute panne de l'unité, assurez-vous que la
régulation de température est suffisante pour répondre aux exigences de l'unité
(refroidissement/chauffage). La température de fonctionnement doit être maintenue dans la plage
(-40° à 60°C/-40° à 140°F), sans condensation d'humidité supérieur à 95%.
